Teldio RBX+ Plus | Option Board Programming

Steps for programming your XPR 7500/e series radio with the Teldio Option Board Firmware

Install the Teldio Programmer.
Connect a portable radio to the computer and run the programmer. Make sure you are on a Teldio enabled (option board enabled) channel.
On the 'Radio' tab type in the Radio ID, Radio IP and press Connect.
Go to the 'Firmware' tab select 'Auto-Select' and then press Program.
- The Firmware till take about a minute to program and then will restart
If using a Signal ID other than the default ID (254):
- Go to the 'Write' tab and under 'Parameter':
  - Select 'Singnal ID' for the Parameter Name field
  - Enter in the ID provided to you by Teldio
  - Press 'Write'

If using Quick Call Feature:
- To use the Quick Call Number feature, a button on the radio must be first mapped to "Option Board Feature 6"
- Go to the 'Write' tab and under 'Parameter':
  - Select 'Quick Call Number' for the Parameter Name field
  - Enter in the number you'd like to dial in the Parameter Value field
    - This number must be entered just as it needs to be dial. For example. if dialling out from the customer system needs a prefix of 7, and you want to dial 911, the number here must be set as 7911
  - Press 'Write'
  - Select 'Quick Call Confirm' for the Parameter Name field
  - Enter in '1' in the Parameter Value field
  - Press 'Write'